Skip to content

Brick/Brick Veneer- Advantages,Types,Installation Method

Brick Veneer

Brick veneer is thinner than the traditional brick siding, easy and lighter handling and effortless installation. It is suitable for both interior and exterior applications.

It also adds warmth, texture and charm to any place and suits any style -traditional, industrial or modern.so the urge to use brick veneer still prevails.

Widely used in the construction industry

It does not support the structural load of the building, it the brick was removed, the house would continue to stand.

Advantages of Brick Veneer

  • Light in weight and easy to install.
  • It requires a very simple support system.
  • Large selection of various colours and textures to suit vintage styles to contemporary styles.
  • Saves time and money on labour.
  • In exteriors, the air cavity between the brick veneer and substrate helps to keep moisture out and acts as an insulating space.
  • It is durable and fireproof.
  • Requires less maintenance.

Thickness

Thickness varies from 1/2″ to 1″.

Format/Type

It is available as

INDIVIDUAL PIECE

PANEL-12 bricks per sheet remounted on fiberglass mesh for quick installation.

CORNER PIECES AND CORNER SHEETS.

Application

Can be applied on both interior and exterior walls. Interior applications such as accent walls, inset panels, ceilings or brick fireplaces, etc. Exterior applications such as brick siding.

Applied on drywall, cement board or cinder wall.

Materials

There are many suitable materials in modern days for masonry veneers. Most common are the materials like natural clay, manufactured clay, natural and artificial stones, cement, sand, concrete, etc.,

Installation Method

The installation method depends on the location (exteriors /interiors), surface (masonry/wood/metal/wallboard, etc.,), type of brick veneer.

In the interior most common method, thin bricks are adhered directly to a suitable substrate surface.

1.Surface Preparation

Masonry surface (brick, block, stucco, concrete)

Clean the untreated masonry surface to ensure it is free from dirt and dust. If the surface is too smooth, hack the surface with an axe to create a rough and pitted surface.

Painted or treated surfaces can be coated with a bonding agent or covered with metal lath.

Over framing (wood or metal) with sheathing (plywood, OSB, paneling, gypsum wallboard, concrete board, fiberboard)

On an exterior surface, a weather-resistant barrier (2 layers) must be installed before installing metal lath.

2.Apply Scratch Coat

Apply thin coat of mortar to completely cover the masonry surface or metal lath to create mortar scratch coat. Scratch the surface horizontally with a rake for a rough surface to provide a strong bonding surface for the veneer.

3.Apply or Install Veneer

Apply a 1/2″ thick mortar to the back of the veneer and press the veneer firmly to scratch coat to ensure good bond.

Corner pieces should be installed first alternating short and long legs.

After the corner pieces apply flat pieces starting at the outside to the center of the wall.

Cut and trim stones to fill any gaps to fit or attractive finished surface.

4.Grouting Joints

A grout bag is used to fill the joints. Fill the grout bag with mortar mixture and squeeze the small end into the joint area to be filled.

5.Finish Joints

After the mortar joints are firm, scrape away all excess grout in the joint for an appealing and professional finish.

6.Clean and Seal Veneer

Use a cleaner to remove any dirt and stains on the veneer face and apply a water-based sealer to keep veneer clean.

Leave a Reply

%d bloggers like this: